The Review step is the plan as the planner computed it. The step rail will not advance to it until the plan describes a dive that can be computed. While the plan is worked out a banner reads Computing dive plan; if no schedule could be produced, a red banner names the reason and offers to run it again.
The five views
| View | Answers |
|---|---|
| Overview, below | What shape is this dive, and what does it come to? |
| Schedule | What do I actually do, minute by minute? |
| Gas Consumption | Do I have enough gas, and where does it run out? |
| Tissue Saturation | Which compartment is driving the ascent? |
| Hybrid Analysis or GF Calibration | What did the second model say? |
The first four are always there. The fifth appears only under the algorithms that produce a second model’s output, and its label changes with the algorithm.
Overview
The dive drawn as a chart, with a strip of readouts beneath it. A legend names the two traces, Depth and Deco Ceiling, and a control at the end of it opens the chart full-screen.
The ceiling trace is the shallowest depth the model would permit at that moment: where it meets the depth trace you are at a stop, and where the gap is wide you are free to ascend. The depth trace is coloured by the gas being breathed.
Six readouts sit below the chart, in this order:
- Max Depth: metres, to one decimal.
- Runtime: whole minutes, surface to surface.
- TTS: time to surface, in whole minutes, from the end of the bottom to the surface with decompression included.
- First Stop: metres. Present only on a dive that has one.
- O₂ CNS: a percentage with a fill bar, amber at 80 % and red at 100 %.
- OTU: unitless, the cumulative pulmonary oxygen dose.
On a rebreather
A closed-circuit plan adds a rail of bailout scenarios above the view, on every view except the models one. Each row is one open-circuit ascent from one point in the dive on one subset of your bailout gases; the first is the Loop, the dive you intend to make. Selecting one recomputes every view for that scenario, and the ceiling trace gives way to the scenarios drawn over the loop profile as dashed lines. See Bailout scenarios.
Next
The schedule view takes the same dive as a stop list. Reference: outputs has every figure the planner reports.